Download Toshiba A200 Personal Computer User Manual

4 Replacement Procedures
4.12 FL Inverter Board
Removing the FL Inverter Board
To remove the FL inverter board, first remove the battery pack, display assembly, and display
mask; then follow the steps below.
1.
Remove the M2x3 black screw securing the FL inverter board to the LCD display
assembly.
Figure 4-38
Removing the screw
NOTE: If a dual inverter board is installed, you must remove two additional M2.5x4
screws.
2.
Disconnect the two connectors on either side of the board.
Figure 4-39
Removing the connectors
Minnesota 10M/10MG Series Maintenance Manual
4-35