Download Canon 6609B074 Digital Camera User Manual

F - 160 Operation and Maintenance Manual
Applications
Parameter Chart 8 - One pass mount and laminate
MATERIALS
U P P E R U N W I N D : 3 mil Octiva Gloss
S U B S T R A T E : 1/4" Foam Core
LOWER UNWIND : N / A
PRINTS :
Electrostatic images
TEMPERATURE
TOP TEMP.
BOT. TEMP.
240
68
GAP & PRESSURE
PRESSURE
GAP
1/4
MOTOR DIRECTION & SPEED
SOLID
= Panel
GO
00.0
SPEED
F L A SH I N G
= Footswitch
FWD
REV.
GO
PULL ROLL SETTINGS
N/A
UP
1/4 Turn
PRESSURE
1/2 Turn
DOWN
3/4 Turn
NOTES
Upper unwind material may be sibstituted with similar product. Substrate can vary. Top temperature will vary
slighly between 240 - 260 o F depending on laminate thickness. Gap will be dependent on the substrate
thickness. Pressure will be determined by the operator. Speed is not indicated in Footswitch mode. Because
the process is described from the front of the laminator, motor direction is FWD and the pull rolls are not
required for this application.
Page 6 - 112
© GBC Pro - Tech August 1999