Download Canon 6609B074 Digital Camera User Manual

F - 160 Operation and Maintenance Manual
Applications
c) Use a piece of masking tape, to adhere the
leading edge of the laminate to the upper rewind
tube.
Process
a) Apply just enough brake tension to prevent the
roll of laminate from free spinning.
d) Wrap one full turn of laminate onto the upper
rewind tube.
INFORMATION
Excessive brake tension may cause the
image to curl when separated from
the craft paper.
CAUTION
Do not cut too deeply into the laminate, you
can cut into the release liner.
b) Pull the laminate to the upper rewind tube.
Refer to Figure 6.4.3
e) With the utility knife, make an incision across
the width of the laminate.
CAUTION
Make note of the rewind tube drive
direction when taping the laminate.
The laminate should separate under
the rewind tube.
CAUTION
Caution should always be exercised
when using a knife .
Sharp knife can cut you!
Figure 6.4.3 Laminate to rewind
f) Remove the front infeed table.
P.S.A.
Laminate
Rewind
tube
g) Pull the laminate straight down toward the front
of the lower main roller. Refer to Figure 6.4.4
Page 6 - 28
© GBC Pro - Tech August 1999