Download Arrow VM1012-B Specifications
Transcript
ENGINE NS/GS 9 - 43 SERVICE PROCEDURES (Continued) Fig. 10 Checking Valve Stand Down Fig. 11 Valve Guide Height FITTING PISTON RING (1) Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore. The ring gap measurement must be made with the ring positioning at least 12 mm (0.50 in.) from bottom of cylinder bore (Fig. 12). Check gap with feeler gauge. Top compression ring gap .25 to .50mm (.0098 to .0196 in.). Second compression ring gap .25 to .35mm (.0098 to .0137 in.). Oil control ring gap .25 to .58mm (.0098 to .0228 in.). (2) If ring gaps exceed dimension given, new rings or cylinder liners must be fitted. Keep piston rings in piston sets. (3) Check piston ring to groove clearance (Fig. 13). Top compression ring gap .08 to .130mm (.0031 to .0051 in.). Second compression ring gap .070 to .102mm (.0027 to .0040 in.). Oil control ring gap .040 to .072mm (.0015 to .0028 in.). CRANKSHAFT END PLAY (1) Attach dial indicator to engine block (Fig. 14). (2) Move crankshaft toward front of engine and zero indicator. (3) Move crankshaft toward the rear of engine and record measurement. Fig. 9 Valve Specification