Download Scene Double SDBX/DA2 User guide

Quick Setup
1. Quick Setup
This section briefly describes how to install your KVM extender system and
optimize the video signals. Unless you are an experienced user, we recommend
that you follow the full procedures described in the rest of this manual.
.
Set Cable Length Jumpers
Remove Remote Unit cover and set all three jumpers to
position for Interconnect cable length (see page 14)
Serial
Extender?
Yes
Set Baud Rate and Flow Control Jumpers
Set jumpers on Remote and Local Units for required
baud rate and handshaking/flow control (see page 39).
Adjustment is not required for most applications.
No
Install system
1.
2.
3.
4.
Connect Remote Unit to KVM and serial device (if
present).
Connect Local Unit or Extender hub to CPU.
Connect Remote and Local Units with compatible
CAT5/5e Interconnect cable.
Power up system.
View Test Card
http://testcard.kvmextender.info
Adjust EQ and Peak controls
Optimize video quality on Remote console monitor (See
page 22)
Any Problems? See
Installation and
Troubleshooting sections.
Provides useful image for
adjusting video.
5