Download Midmark M11 Specifications

Cycle Operation - continued
After the cycle button is pressed, the parameters for that cycle will appear on the display.
Note
On units using the metric display, °F will display as °C and PSI will display as KPA.
Pressing
enables operator to change DRY time from 0 to 60 minutes in 1 minute
increments on a pre-set cycle.
Pressing
decreases time. Pressing
increases time.
MA596700i
Start
Stop
MA596700i
WARNING
STOP button may be pressed at any time to stop or interrupt a cycle. Goods must not be considered sterile if this occurs
before the Dry Cycle. Sterilizer will return to SELECT CYCLE mode.
Step 3: Press ‘Start’ button to initiate cycle.
You will hear a “beep” for two seconds, indicating the cycle has started.
TP202 Rev. A
21
© Midmark Corporation 2013