Download Shure DFR11EQ Version 5 Specifications
Transcript
ENGLISH DIP SWITCHES DIP SWITCH 2 3 4 +4 INPUT DN 1 -10 4 UNUSED 3 +4 OUTPUT UNLOCK FRONT PANEL 2 -10 UPDATE LOCK UP 1 UNUSED HIGH Q HOLD DEVICE ID LOW Q There are ten DIP Switches located on the back of the DFR11EQ. The following table describes the function of each switch. See the DFR11EQ User’s Guide on the Software CD ROM for instructions on how to set the Device ID. FUNCTION POSITION UP DOWN 1-4 Shure Link Device ID (see CD-Rom user guide) 5 Feedback Filter Bandwidth Select Determines the Q of the feedback filter. High Q 1/10–octave Feedback Filters remain narrow as they deepen Low Q 1/10–octave Feedback Filters widen as they deepen 6 Feedback Filter Memory Mode Update Stores changed feedback filter settings on power down Hold Discards changed feedback filter settings on power down, but holds original settings 7 Front Panel Lockout Unlock Front Panel Front panel buttons operational Lock Front panel buttons inactive (except the power switch). 8 unused - - 9* Output Sensitivity +4 dBu Output –10 dBV Output 10* Input Sensitivity +4 dBu Input –10 dBV Input *NOTE: See the Set Up instructions in the Using the DFR11EQ as a Stand-Alone Feedback Reducer section of this Quick Reference Guide for instructions and warnings regarding use of the Input and Output Sensitivity DIP switches. HOLD/UPDATE UPDATE position... When the HOLD/UPDATE DIP switch is in the UPDATE position (default), the DFR11EQ saves the feedback filters every time the unit is powered off. When the DFR11EQ is powered on again, the feedback filters will be at exactly the same settings as when the unit was powered down. HOLD position... When the HOLD/UPDATE DIP switch is changed to the HOLD position, the DFR11EQ immediately saves the feedback filters at the current settings. When the DFR11EQ is powered off, any changes made to the feedback filters after the switch was set will be forgotten. When powered on again, the feedback filter settings will be exactly the same as when the HOLD/UPDATE DIP switch was changed to the HOLD position. This feature is useful for storing the best filter settings for a sound system. To store filter settings in the HOLD memory: 1. 2. 3. 4. 5. Set the Hold/Update DIP switch to the Update position; Ring out the room until all fixed filters are set; Set the Hold/Update DIP switch to the Hold position; During the performance, the DFR11EQ will change dynamic filters and deepen fixed ones; After the performance, turn the power off and back on; the DFR filters are restored to the state they were in before the performance. 5