Download Microsoft WIhipi-2300 User manual
Transcript
22. Common problems and solutions If you encountered problems while operating your device, the following troubleshooting tips may help resolve the issue. If the problem persists, please contact your dealer or service operator. Common problems Reasons Network service operator does not Fails to connect provide such service, or you have to network not subscribed to the service. using Internet Incorrect configuration of Internet Explorer Explorer SIM card is warped or damaged. SIM card is not properly installed. SIM card error Poor signals Fail to power on Fail to make a call Fail to connect to network Metal surface of SIM card is unclean. Using your phone in places that may result in a poor signal of your phone, like surroundings of high buildings, or in a basement where radio waves become unreachable. Using phone during the period of busy communication, which may results in a channel jam and inability of communicating. Using an excessively low battery. Call barring service enabled. SIM card invalid Out of GSM service area Poor signals Fail to charge The battery voltage in use is not in the range specified by charger. Using a non-standard charger Improperly connected to the main power. Solutions Consult network operator for information about how to subscribe a service. Refer to Section. Getting connected. Consult your network operator. Check SIM card. Change to a new one if necessary. Clean the metal surface with a clean cloth or tissue. Receive calls in places where a good signal is available. Avoid being within such a situation or similar. Charge it, or replace it with a new one. Disable it in Settings > Phone Consult your network operator Relocate your phone into service area of network operator. Relocate your phone to places with strong signals, then try again. Use batteries with proper voltage range. Use a charger designed for this type of phone. Check the connection in between.