Download Vaisala DRYCAP DMT346 User`s guide

Chapter 4 _________________________________________________________________ Operation
Table 25
Selection of Output Modes
Mode
STOP
RUN
POLL
Output
Only by command
Automatic output
Only with command SEND [addr]
SEND
One message at power-up
Commands used
All (default mode)
Only command S
Use with RS-485 buses, see
RS-422/485 Interface on page
48.
Selected output mode will be activated after power outages.
INTV
Use the command INTV[xxx yyy] to set the outputting interval for the
RUN mode.
Syntax: INTV[xxx yyy]
where
xxx =
yyy =
Output interval (0 ... 255). 0: the fastest possible output rate.
Unit (s, min or h)
Example:
>INTV 10 min
Output intrv. :
>
10 min
ECHO
Use the command ECHO [x] to set the user port echo. The command
either enables or disables echo of characters received.
Syntax: ECHO [x]
where
x
NOTE
=
=
ON (default) or
OFF
You can use the SERI, SMODE, INTV and ECHO commands to
change/view the user port settings even if you are currently connected
to the service port.
VAISALA________________________________________________________________________ 77