Download Sharp R-426H Technical data
Transcript
1. Specifications 1-11 Installation Instructions ■ Electrical Wiring • Indoor Unit Type (F) Power Supply 2.5 mm2 Time Delay Power Supply Terminal Base Fuse or Capacity Max. Wire Circuit Diameter Capacity X, S, AS, T, U, SL 245 m 15 A 50 A 14 mm2 (AWG#6) K 588 m 15 A 25 A 5.5 mm2 (AWG#10) D 89 m 15 A 50 A 14 mm2 (AWG#6) Control Wiring (C) Inter-Unit Control Wiring 0.75 mm2 (AWG#18) Use Shielded Wiring Max. 1000 m 1) (D) Remote Control Wiring 0.75 mm2 (AWG#18) (E) Control Wiring For Group Control 0.75 mm2 (AWG#18) Max. 500 m Max. 500 m NOTE Refer to the Wiring System Diagrams (Ref. next page) for the meaning of “A”, “B”, “C”, “D”, “E”, and “F” in the above tables. 2) Inter-Unit Control Wiring (c) has no polarity. But for other wiring, respect polarity. Be sure to connect as shown in the Wiring System Diagram. 3) The basic connection diagram of the indoor unit shows the 8P terminal board, so the terminal boards in your equipment may differ from the diagram. 4) 8P terminal board 5P terminal board + 3P terminal board 1 1 2 U1 U2 R1 R2 R3 1(L)2(N) Power supply R1 R2 R3 Remote U1 U2 controller Inter-unit control wiring 0511_M_I 1 2 3 4 5 1(L)2(N) 4 5 1 2 3 Power Inter-unit Remote supply control wiring controller 0512_M_I Only for K type In accordance with conformity of EC Directive No. 89/336/EEC, when connecting power supply, it should be considered guidance showing below. * * 2 Do not share a common installation group with other equipment. Be sure that supply network impedance is sufficiently low ( ZSYS RΩ). It may be necessary to consult the power supply authority before connection of the air conditioner to a low-voltage public network. I I[ 3 R407C Models Models RΩ Remarks 25 type (3 phase) — Not necessary to consider supply network impedance 36 type (3 phase) 0.192 Conforms to the local code 48 type (3 phase) 0.167 Ditto 25 type (1 phase) 0.126 Ditto 4 5 I - 105 SM830080