1
Download unication E5 Specifications
Transcript
6 Programless Communications 6-3-3 Range of Operation for Programless Communications Programless communications start operating after the power supply is turned ON or after the E5@C-T is reset. They stop operating when the initial setting level is entered. Levels 6-3-4 Programless communications Operation level, program setting level, adjustment level, PID setting level, manual control level, monitor/setting item level, and protect level Setting area 0 Operates Initial setting level, communications setting level, advanced function setting level, and calibration level Setting area 1 Stops Operation Command Codes The following table gives the operation command codes that can be set. For details on operation commands, refer to 2-3-8 Operation Command. Operation command Switch 0100 0101 RESET AT Execute/Cancel 0300 AT Cancel 0301 100% AT Execute 0302 40% AT Execute Write Mode RUN 0303 All PID 100% AT Execute 0304 All PID 40% AT Execute 0400 Backup Mode 0401 RAM Write Mode Save RAM Data 0500 Save RAM Data Software Reset 0600 Software Reset Auto/Manual 0900 Automatic Mode Alarm Latch Cancel SP Mode 0901 Manual Mode 0C00 Alarm 1 Latch Cancel 0C01 Alarm 2 Latch Cancel 0C02 Alarm 3 Latch Cancel 0C03 Heater Burnout Latch Cancel 0C04 HS Alarm Latch Cancel 0C05 Alarm 4 Latch Cancel 0C0F All Latch Cancel 0D00 Program SP Mode 0D01 Fixed SP Mode Invert Direct/Reverse Operation 0E00 Do Not Invert 0E01 Invert Hold 1300 Hold cleared. 1301 Hold Advance 6-3-5 Operation command code RUN/RESET 1400 Confirming Operation of Programless Communications You can check the operation of programless communications in the Communications Status in the upload area. The value of the Communications Status changes between 0 and 1 each time the upload area is updated. 6-3-6 Write Mode The E5@C-T normally writes the set values to non-volatile memory (i.e., in Backup Mode). If you frequently change set values with programless communications, use an operation command to change to RAM Write Mode. 6 - 22 E5C-T Digital Controllers Programmable Type Communications Manual (H186)
