Download Craftsman 580.752710 Operating instructions
Transcript
Pressure Washer How to Use the Hose Ree_ Rinsing Your cleaning system is equipped with a hose reel designed to store the hose when unit is not in use. See "Prepare Unit for Storage" for long term storage of more than 30 days. After detergent is applied, scour the surface and rinse it clean as foJlows: 1. Apply trigger Jock to spray gun. 2. Make sure both chemical shut-off valves are in After each use: "Off" position. 3. Remove Mack ProjectPro TM cleaning detergent nozzle from nozzle extension. 4. Select and instaJJdesired ProjectPro TM nozzJe, as described in "How to Use ProjectPro TM Nozzle System". Keep spray gun a safe distance from spray surface. 5. 1. Disconnect hose from spray gun and high pressure outlet on pump. 2. Drain water from hose. 3. SJide one end of hose into hoJe on hose reel. Turn hose reeJ with handle to coil hose onto reel WARNING Keep spray nozzle cleaning surface, Operate between this unit on a stable Be extremely careful grasp pressure spray away from surface, if you must use the pressure washer from a ladder, unstable location, Firmly 8 to 24 inches scaffolding gun with spray to avoid injury or any other both hands when if gun kicks relatively using iMPORTANT: DO NOT use your cleaning system with the hose coiled onto the hose reel The hose reeJ is for storage purposes only. high back. Automatic 6. 7. Apply a high pressure spray to a small area and then check the surface for damage, if no damage, proceed to step 7. Coo_ (Therma_ Down System Relief) If you run the engine on your pressure washer for 3-5 minutes without pressing the trigger on the spray gun, circuJating water in the pump can reach temperatures above 125°F. The system engages to cool the pump by discharging the warm water onto the ground. Start at top of area to be rinsed, working down with same overJapping strokes used for cleaning. 14
This document in other languages
- español: Craftsman 580.752710