Download Sinclair Pneumatic Grommet Machine PG-21 Technical data
Transcript
6 MAINTENANCE. There is no need to lubricate any mechanical parts of the machine. For an optimum operation of the EP-300 it is important to have some parts clean, and this operation should always be done with a) the main air inlet valve on position “OFF” and b) the main switch on “OFF” position (no light on). The raceways where eyelets and washers come down should be always kept clean; we recommended doing it at the end of the day with compressed air. Any threads or small parts on the raceways may stop the eyelets and washers from coming down. It is important to clean setting area, especially the top die where threads will remain on the puncher as marked on Fig. 9. Fig. 9 Fig. 10 We recommend doing it with an air gun through the open space on the safety cover in the front of the machine. This operation should be done at least once per day, but depending upon the type of materials used might be necessary to increase the timing between cleaning. The push button should always be clean and clear of any parts that could interfere on its normal operation. The outer parts of the machine should be cleaned with a cloth that will leave no threads (really important on the raceway channels were eyelets/washers come down). If the machine is going to be a long period with no use please follow these recommendations: 1. 2. 3. 4. Disconnect it from the compressor Disconnect it from the power source. Clean it. Cover it to avoid humidity and dust. It is important that the machine is connected to a compressor or local air installation with an air filter.