Download Siemens RDG Technical data

Transcript
The Economy setpoints are accessible at the service level (P11, P12); the
Protection setpoints at the expert level (P65, P66).
3.3.2
Setting and adjusting setpoints
Room temperature setpoints can be
– set during commissioning
– adjusted during runtime
KNX
R
Comfort basic setpoint
Comfort setpoint
The source can be
– the local HMI
– a tool
– a central control unit
The thermostat stores the setpoints
– in EEPROM in the form of parameters
– in the runtime memory
The table below shows the interrelations:
Setpoint setting
Commissioning
– HMI
– Tool download
Comfort basic setpoint
Dead zone Comfort 1)
Setpoint Economy Heating
Setpoint Economy Cooling
Setpoint Protection Heating
Setpoint Protection Cooling
Input LTE mode
Input S-mode
Setpoints Heating
Setpoints Cooling
Setpoints Heating
Setpoints Cooling
Comfort basic setpoint
Current runtime
setpoints in
thermostat
Comfort setpoint
Economy Heating
Economy Cooling
Protection Heating
Protection Cooling
Effective room operating mode
Stored in EEPROM
of thermostat
Setpoint
adjustment
Input LTE mode
2)
Setpoint shift H
Setpoint shift C
Setpoint shift H
Setpoint shift C
Input S-mode
3)
Comfort setpoint
P08 Comfort basic setpoint
P33 Dead zone Comfort 1)
P11 Economy Heating
P12 Economy Cooling
P65 Protection Heating
P66 Protection Cooling
New current
runtime setpoints
in thermostat
Local operation 3)
Rotary knob
Comfort setpoint
Economy Heating
Economy Cooling
Protection Heating
Protection Cooling
Current setpoint (used by the thermostat for temperature control)
1) Only required for heating AND cooling applications (see section 3.6.10)
2) LTE mode: the shift is added to the local shift
3) S-Mode: the last intervention wins, either S-Mode input or local operation
21 / 86
Siemens
Building Technologies
RDG100KN Basic documentation
Functions
CE1P3191en
22 Jun 2010