Download Universal Remote Control DMS-100 User guide
Transcript
>MAPCI NODISP use to suppress the MAP level display. >MSG sends a message to another user (i.e., MSG NTAS ‘Hello’). >NAG Node Assessment Graph (NAG) is an hourly snapshot of equipment status, REX, and overload (see NAG400 log). >PERMIT defines a new valid user and assigns parameters. >UNPERMIT removes an existing user. >PRIVCLAS adds, deletes, or changes, the privilege class(es) for specified command(s) or program module(s). >OMPRDUMP Request OMPRSPEC reports from the OMTAPE data. Query Commands: >QCUST retrieves information about all the lines associated with one or more customer group(s). >QDN dn displays information about a subscriber line. >QDNWRK displays a range of working lines using directory #’s. >QGRP display various equipment groups using DN or LEN. >QHASU display hardware assigned and software unassigned. >QHLR displays DN in HLR for mobility numbers. >QLEN len displays information about a subscriber line. >QLEN dn displays complete information about a subscriber line. >QLENWRK used to query a range of working lines using LENs. >QMADN display Multiple Appearance Dir. Number (MADN). >QPDN list ported in and out DNs and ported DNs of a single NPANXX Note: The following QUERYCM and QUERYMS commands are dependent upon table PECINVs datafill being current. >QUERYCM hidden command off the CM MAP level used to query information on CM hardware. Use HELP QURYCM. >QUERYMS hidden command off the MS MAP level used to query information on MS hardware. Use HELP QUERYMS. >QUSER displays a list of user names and associated devices. >QUSER COMPLETE includes names, devices, and processes the user is running in. (see QUERY PROCID). >QUERY PROCID <procid> displays what process has been started by the user (use the PROCID field data from the QUSER COMPLETE command). >RECORD QUERY displays all recording links. >TRKQUERY TM <TMTYPE> <TMNO> displays TM ckt. info. >TRKQUERY PM <PMTYPE> <PMNO> <CKT> disp’s ckt info. >QUIT used to change current display to the previous directory. >RCCMAP gives information on the channel usage of an RCC - LTC. >RECORD START sends output from your dev. to dev. ispecified: >RECORD START ONTO <device name> sends output to device specified. >RECORD START FROM <device name> ONTO <device name> sends output from and to devices specified. >RECORD STOP stops recording: >RECORD STOP ONTO <device name> >RECORD STOP FROM <device name> ONTO <device name> >RENAMECLLI <old_clli> <new_clli> chg. clli names in CLLI table. >REPEAT used to repeat CI expression specified number of times. (Ex:, >REPEAT 3 (NEXT) to repeat next command 3 times). >SEND redirects the user's terminal response to an alternate device: >SEND <device> <filename> terminal response sent to file. >SEND <device name> terminal response sent to dev. specified. >SEND PREVIOUS resets terminal response to original terminal. >SHERLOCK request data for service failure analysis. >SHOW USERS displays valid users list (use PRINT USERS for copy). >SHOWUSES <table> displays dependency table(s) for specified table. >SHOWUSERS <table> displays tables that use the specified table. >SSR 15 min. switch status report—try DISPLAY SSR600 VERBOSE command. See tables SSRFORM & SSRDEF. 9