Download DataCard RL90 User guide

Printer error recovery
Bend remedy laminator settings
When the laminated card warps
concave, the printer bend remedy
settings should be effective in
correcting the problem. See Bend
remedy printer settings on the
previous page.
If the laminated card warps convex,
set the printer’s Bend Remedy> Temp
Level to Off and set the laminator’s
Card Fan to one of five settings.
Set the printer’s Bend Remedy>Temp
Level to Off when laminating cards that have been printed on both sides.
To set the laminator Card Fan:
RP90 and RL90 User Guide
1
Press the MENU key on the laminator’s LCD display until “Card Fan” is
displayed.
2
Press the ENTER key.
3
Press the RESET/ key to select from five settings: Off, Low, Half,
High, or Full. You may need to experiment with this setting to obtain
satisfactory results. Remember to allow sufficient time for the bend
remedy roller to cool after decreasing the temperature setting.
4
Press the ENTER key to confirm the setting.
45