Download CCTV Tester Pro User`s manual

CAUTION
Make sure to check CAMERA ID, PROTOCOL,
BAUDRATE when testing. PTZ operation can not be
done when the setup is different from the camera. If you
are unsure of the cameras configuration, connect the
camera to the Video IN of SecuriTEST then cycle the
cameras power. Often the camera will display its PTZ
configuration during the boot process allowing the tester
to be set to a matching configuration.
UTP Cable Tester
Connect one end of the UTP cable to be tested to the
UTP Cable Test port of SecuriTEST and the other end to
the yellow UTP Cable terminator.
The
condition
of
the
cable
can
be
tested
by
pressing
. The test can detect straight and
crossover cables as well as shorts, opens and most
miswire conditions.
36