Download Sharp LC-32SB24U Operating instructions

Transcript
QUICK REFERENCE
Before attaching (or detaching) the stand, unplug the AC
cord from the AC iNPUT terminal.
Before perfo/ming work spread cushioning over the base
area to lay the TV on This will prevent it from being
damaged.
• Attach
the stand in the correct
direction.
Do not remove the stand from the 1_/unless using an
optional wall mount bracket to mount it.
• Be sure to follow the instructions.
Incorrect installation
of the stand may result in tbe TV falling over.
1 Confirm
supplied
that there are 9 screws
with the stand unit.
Y4_l'_f/f_%
• This TV sbould be mounted on tbe wall only with the
AN-gTAG5 (SHARP) wall mount bracket. The use of
other wall mount brackets may result in an unstable
installation and may cause serious injuries.
= Installing the TV requires special skill that should
only be performed by qualified service personnel.
Customers should not attempt to do the work
themselves.
SHARP bears no responsibility
for
improper mounting or mounting that results in
accident or injury.
Using
and a hex key
an optional
bracket
to mount
the
"rv
• You can ask a qualified service professional about
using an optional AN 37AG6 bracket to mount the TV
to the wall.
2 Attach the supporting
post for the stand unit onto
the base using the box for the stand unit as shown
below.
• Carefully read the instructions
that come with the
bracket before beginning work.
f
Hanging
Hoxkoy_ @ C'r_=
AN 37AG5
on the
wall
wall mount
(See the bracket
bracket.
instructions
Vertica] mounting
About setting
0/5/10/15/20
for details.)
Angular mounting
the 13/angle
<
LC-32SB24U
3
r_ Insert the stand into the openings
of the TV.
"2', Insert and tighten the 4 screws
on the rear of the TV.
on the bottom
into the 4 holes
The center of the display:
_/,_ il/ch (4.0 mm} ul/der
the "A" position.
LC-37SB24U
The center of the display:
1/4 inch (6.0 ram) above
the "A" position.
_'f_
_ _'_s .......
Soft c
* To detach the stand, perform the steps in reverse order
Refer to the operation
manual d AN 37AG5
details.
for
Detach the cable clamp on the rear of the %/when using
the optional mount bracket.
Due to the terminal configuration on this %/, when you
walPmount this model, make sure there is enough space
between the wall and the %/for the cables,
To use this %/mounted on a wall, first remove the
adhesive tape at the 4 locations on the rear of the %/, and
then use the screws supplied with the wall mount bracket
to secure the bracket to the rear of the %/