Download Radlink CR Pro Installation guide
Transcript
Electromagnetic Interference (EMI) is any signal or emission, radiated in free space or conducted along power or signal leads, that endangers the functioning of a radio navigation or other safety service or seriously degrades, obstructs, or repeatedly interrupts a licensed radio communications service. Radio communication services include, but are not limited to, AM/FM commercial broadcast, television, cellular services, radar, air-traffic control, pager and Personal Communication Services (PCS). These licensed services, along with unintentional radiators such as digital devices, including computers, contribute to the electromagnetic environment. While this device has been designed and determined to be compliant with regulatory agency limits for EMI, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference with radio communication services, which can be determined by turning the device off and on, you are encouraged to correct the interference by one or more of the following measures: • Re-orient or relocate the receiving antenna. • Relocate the device with respect to the receiver. • Increase the separation between the equipment and receiver. • Connect the equipment to an outlet on a circuit different than that to which the receiver is connected. • QUALIFIED SERVICE – All service must be performed by the factory or an authorized service technician. There are no user replaceable parts inside the CR Pro. DO NOT remove the covers as internal parts may be damaged, the warranty will be voided and it may be hazardous to your health. • SPACE REQUIREMENTS – The CR-Pro utilizes 36in (91.4cm)(w) x 24in( 61cm)(d) x 58in(147.3cm) (h) minimum. • POWER REQUIREMENTS – Domestic (U.S.): AC outlet 100V – 120VAC, 60 Hz, 5A European: AC outlet 200V – 240VAC, 50Hz, 3A 4