Download Combi Flash EX 655 Specifications
Transcript
Installation and preparation 4.2 Operation manuals of the pump and accessories Fluid Heaters can only be used in conjunction with spraying equipment. Therefore, all instructions covering unit preparation, commissioning, operation and shutting-down must be compared to those covering the spraying equipment itself for compatability. ➤➤ Read and observe the instructions found in the operation manuals for the spraying equipment, the fluid heater and any additional spray accessories. ➤➤ Pay special attention to chapters covering safety in the operation manuals. 4.3 Electrical power connection The heater is equipped with a permanent power connection cable without plug. ➤➤ Connect the heater to the power supply. IIn areas with risk of explosion the power connection must be explosion proof. For versions without cable and cable connection, mount approved cable connectors. Warning This should only be done by trained electrical personnel. Observe the explosionproof zoning for your workplace. ➤➤ Before connecting the Fluid Heater to the electrical supply, check to ensure that the point of hook-up is functioning correctly and no faults are present. 4.4 Mount the Fluid Heater Depending on the application, you can mount the material flow heater in different ways (see chap. 3.5 Equipment versions on page 21): ➤➤ On a holder onto the spray device or system, ➤➤ On a wall bracket ➤➤ On a carrier base There are four drilled holes on the housing to screw the material heater tight to the holder. 4.5 Ground the unit A separate grounding of the Fluid Heater is required when no electrically-conductive connection to the spray unit exists (refer chap. 2.4.2 Ground Cable on page 13). Translation of the original operation manual MDFE_mAtex_1307_en • jw 25