Download Samson 1400 Operating instructions
Transcript
Attachment to the control valve – Mounting parts and accessories 4.5 Reversing amplifier for double-acting actuators For the use with double-acting actuators, the positioner must be fitted with a reversing amplifier, e.g. the SAMSON Type 3710 Reversing Amplifier (see Mounting and Operating Instructions EB 8392 EN). 4.6 Attaching an external position sensor Refer to Table 7 on page 44 for the required mounting parts and accessories. In the positioner version with an external position sensor, the sensor placed in a separate housing is attached over a plate or bracket to the control valve. The travel pick-off corresponds to that of a standard device. The positioner unit can be mounted as required to a wall or a pipe. For the electrical connection a 10 meter connecting lead with M12x1 connectors is included in the scope of delivery. Note: – In addition, the instructions in sections 5.1 and 5.2 apply for the pneumatic and electrical connection. Operation and setting are described in sections 7 and 8. – Since 2009, the back of the position sensor (20) is fitted with two pins acting as mechanical stops for the lever (1). If this position sensor is mounted using old mounting parts, two corresponding Ø 8 mm holes must be drilled into the mounting plate/bracket (21). 4.6.1 Mounting the position sensor with direct attachment Type 3277-5 Actuator with 120 cm² The signal pressure from the positioner is routed over the signal pressure connection of the connecting plate (9, Fig. 13 left) to the actuator diaphragm chamber. To proceed, first screw the connecting plate (9) included in the accessories onto the actuator yoke. Turn the connecting plate (9) so that the correct symbol for the fail-safe position "Actuator stem extends" or "Actuator stem retracts" is aligned with the marking (Fig. 13, below). Make sure that the gasket for the connecting plate (9) is correctly inserted. The connecting plate has boreholes with NPT and G threads. Seal the threaded connection that is not used with the rubber seal and square plug. 4 Fig. 12 · Positioner unit with sensor mounted on a micro-flow valve For the pneumatic connection either a connecting plate (6) or a pressure gauge bracket (7) must be fixed to the housing, depending on the accessories chosen. Make sure the seal rings (6.1) are correctly inserted (see Fig. 6 on page 27, bottom right). 34 EB 8384-6 EN 4 4