Download Meyer 7200 Specifications

MONTHLY LUBRICATION
L12 Maintain oil level in the corner gearbox at the
centerline of the input shafts. Check regularly for any
observable oil leakage. If oil leakage is excessive,
replace required input/output shaft oil seals. Use
ONLY EP #80-90 wt. gear lube oil or an equivalent in
corner box, only Lighter weight gear lube oil may be
used in temperatures lower than 20°F. Change oil in
the gearboxes after the first season of use and
regularly thereafter.
ON CORNER OF
FRAME
L13 Grease (1) brass bushing supporting the rear
shaft of the 3rd auger assembly. This zerk is located
on the left rear corner of the tank above the inner
cross brace.
L14 Maintain
the lube level in the (2) spinner
gearboxes at 3/4 full. Check regularly for any
observable leakage. If leakage is excessive, replace
required input/output shaft seals. Lubricate with
Semi-Fluid, EP Lithium Base, Gear Grease.
L15 Clean
and repack the wheel hubs with axle
grease annually. Grease hub through zerk in hub
monthly. Be careful not to over grease and force seal
out of back side of hub.
L16 Oil slides on front idler tightener assembly.
L17 Grease (4) material guide pin sleeves.
located on each side of the spreader.
ON CORNER
OF FRAME
(2)
L18 Grease (2) T-post hold down sleeve zerks lo-
cated above the cross channel on the underside of
the spreader. A zerk is located on the front and one
on the rear of the sleeve.
(SHIELDS REMOVED FOR ILLUSTRATIVE
PURPOSES ONLY.)
Model 7200
-21-