Download Seagate MEDALIST 275XE Installation guide

Medalist XE Family Installation Guide, Rev. A
4-pin
power connector
1
2
3
2-pin
header
Circuit board
4
–
+
F
ro
nt
+5V
+5V return
+12V return
+12V
Drive activity
LED
(optional)
Pin 1
40-pin
ATA interface
connector
8-pin
master/slave jumper block
7 5 3 1
3-pin
power connector
(optional)
Keyway
1 2 3
Circuit
board
3
Ground
+12V
+5V
Front
Spare jumper
across pin 1 and pin 3
8 6 4 2
The drive is a master;
the slave is either a
Medalist family drive or
another ATA-compatible
drive, or there is no slave.
The drive is a master;
a slave is present, but
it is not ATA-compatible.
The drive is a master; a
slave is present that uses
only the PDIAG– signal.
The drive is a slave to an
ATA-compatible master.
Cable select
Figure 1. Jumpers and connectors