Download ASSEMBLY MANUAL

3. From that mark measure 1/2” toward the wing
tip and mark the leading edge of the aileron as
shown. This mark will be the center of the aileron control horn.
Note:The control horns have been purposely offset
from 90 degrees to servo arm to allow for full servo
strength at full deflection
Note: The control horn mounting holes may have
been factory drilled for you. If so, go to the next
step.
5. Use a 1/16” bit to drill the control horn mounting holes.
4.
6. Mount the control horn using six wood screws as
shown.
Note: The control horn mounting holes may have
been factory drilled for you. If so, go to the next
step.
Tape the inboard trailing edge of the aileron to
the trailing edge of the wing in the neutral position. Plug the servo into the receiver and turn
on. Ensure the servo is centered and the servo
arm is parallel to the aileron hinge line. Attach front ball link to servo arm. Adjust the
length of the pushrod so that the leading edge
of the control horn is aligned with the leading
edge of the aileron. Center the control horn
over the mark as shown and mark the position
of the control horn mounting holes.
Note: Use thin CA to lock screws in place
12