Download Miele G880 Operating instructions

Dishwasher installation
4. Aligning the control panel
with the drawer fronts.
The control panel can be aligned
with the drawer fronts of the kitchen
cabinets by adjusting the spacer
bars.
5. Installing the custom
door panel.
A custom door panel matching the kitchen cabinetry can be installed on the
dishwasher by using the provided templates and bracket.
Length: 21" - 25 3/4" (53.3 - 65.4 cm)
Width:
23 1/2" (59.8 cm)
Note: The maximum panel length is
only applicable when no spacer bars
are used.
If a Stainless Steel panel is being used,
please follow the separate installation
instructions included with the panel.
After panel installation, see Step 6 “Adjusting the door springs”.
Using an 8 mm socket, turn the nut
clockwise or counterclockwise until
the spacers reach the required
height.
If necessary, individual (or all)
spacer bars can be removed.
Adjustment range
from 4 1/2" control panel with(112 mm): out spacer bars,
to 5 3/4"
(145 mm):
control panel with
four spacer bars,
to 6":
(154 mm):
using a fifth spacer bar
(optional accessory).
After adjusting the control panel
height, cut off the plastic screw excess.
Place a template on each end of the
bracket as shown, making sure the
rule marks face the outside of the
bracket.
51