Download DCS WDU models Specifications
Transcript
UC864-E/G/WD/WDU AT Commands Reference Guide 80304ST10041a Rev. 7 - 2010-10-14 3.5.3.5. Compression Control 3.5.3.5.1. Data Compression - +DS +DS - Data Compression AT+DS=[<dir>[,<neg Set command sets the V42 compression parameter. >[,<P1>[,<P2>]]]] Parameter: <dir>. : desired direction of operations 0 - no compression (factory default) 1 - Transmit only. 2 - Receive only. 3 - Both directions, accept any direction. <neg> : whether the DCE should continue to operate if the desired result is not obtained. 0 Do not disconnect if V.42 bis is not negotiated by the remote DCE as specified in <direction>. <P1> : maximum number of dictionary entries 512-2048 (Factory default is 2048) AT+DS? AT+DS=? Reference 3.5.3.5.2. <P2) : the maximum string length 6 – the only supported value Read command returns current value of the data compression parameter. Test command returns all supported values of the parameter <n> V25ter Data Compression Reporting - +DR +DR - Data Compression Reporting AT+DR=<n> Set command enables/disables the data compression reporting upon connection. Parameter: <n> 0 - data compression reporting disabled; 1 - data compression reporting enabled upon connection. Note: if enabled, the following intermediate result code is transmitted before the final result code: +DR: <compression> AT+DR? Read command returns current value of <n>. Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 56 of 318