1
Download Scag Power Equipment STHM-20CV Operating instructions
Transcript
TROUBLESHOOTING CAUSE CONDITION Uneven Cut on Flat Ground - Wavy High-Low Appearance, Scalloped Cut, or Rough Contour CURE Lift worn off of blade Replace blade Blade upside down Mount with cutting edge toward ground Deck plugged,grass accumulation Clean underside of deck Too much blade angle (deck pitch) Adjust pitch and level Deck mounted improperly See your authorized SCAG dealer Bent spindle area See your authorized SCAG dealer Dull blade Sharpen blade Uneven ground May need to reduce ground speed, raise cutting height, and/or change direction of cut Tire pressures not equal Check and adjust tire pressure Wheels uneven Check and adjust tire pressure Deck mounted incorrectly See your authorized SCAG dealer Width of Deck SGB020 Uneven Cut on Uneven Ground Wavy Appearance, High-Low Scalloped Cut, or Rough Contour Width of Deck SGB021 Sloping Ridge Across Width of Cutting Path Width of Deck SGB023 12
