Download HP Workstation Z210 SFF User guide

4.
Push the sled containing the HDD into the selected bay until it snaps into place (1) as shown in the
following figure.
Figure 9-3 Installing the HDD drive
5.
Attach a power cable (2), and a data cable (3), to the hard disk drive.
CAUTION: To avoid crushing or pinching the data cable when you replace the access panel,
use the HP-supplied data cable with right-angle connectors.
NOTE: Connect data cables to lower-numbered drive connectors first on the system board. To
identify hard disk drive ports, refer to the workstation service label on the side access panel.
NOTE: Blue SATA ports (numbered zero and one) support SATA Gen 3 (6 Gbit/sec).
6.
Replace all components that were removed in preparation for component installation.
Installing an HDD in an HP Z210 SFF Workstation
To install an HDD:
1.
ENWW
Follow the procedures described in Preparing for component installation on page 34 to prepare
the workstation for component installation.
Installing a hard disk drive
47