Download Seagate ST118273WC User`s guide

Attaching Devices to the Asynchronous Serial Interface
2.
Instruct the system to use the new (latest) /etc/inittab settings by entering
init q
3.
Add an (optional) entry to /etc/ttytype. Entries should conform to the
format documented on the ttytype(4) man page. The following are two sample
entries:
2392 console
2392 tty0p3
2392 is the terminal type, while console and tty0p3 are the device file
names in the /dev directory.
4.
The HP-UX operating system will now communicate with the new terminal.
Verify that the communication parameters for the terminal correspond to their
/etc/gettydefs entries. With the configuration complete, your terminal
should display a login prompt.
Modem Interface Configuration
To add a modem, you need to configure the HP-UX operating system to recognize
both the serial port and the modem protocol. Read the following procedure and
the modem documentation before starting configuration.
NOTE
This procedure does not refer to the RSN modem, which is set up
according to the procedures documented in the HP-UX Operating
System: Fault Tolerant System Administration (R1004H).
Use the following procedure to configure a modem through the SAM interface:
1.
Invoke the SAM interface by entering
sam
2.
From the initial screen, move through the following menus:
Peripheral Devices -> Stratus Devices -> ASYNC SERIAL INTERFACE ->
ADD TERMINAL/MODEM. (SAM includes online help if you need assistance.)
3.
You are presented with a series of prompts. Enter the appropriate information
as requested.
HP-UX version 11.00.01
Configuring Asynchronous Serial Interfaces
7-7