Download SJ-FS676V - Sharp Australia Support

INSTALLATION
WARNING
■■ Do not install the refrigerator in a damp or wet location
as this may cause damage to the insulation and a
leakage. Condensation may also build on the outer
cabinet and cause rust.
the 4 screws of the cabinet lower part, and
4 Remove
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
adequate ventilation space around the refrigerator.
1 Keep
••The figure shows the minimum required space for
installing the refrigerator. The amount of space
Screw
(4 screws)
around the refrigerator affects the amount of power
consumption.
••Insufficient spacing will decrease cooling efficiency
and increase energy consumption. This may reduce
the life of the unit and void warranty.
90mm
or more
the power plug to a 230/240 volt. 10 amp.
5 Connect
power point.
1180 mm
60mm
or more
Foot cover
60mm or more
or more
60mm
Screw
1500 mm
Free standing type
the two front adjustable feet, to ensure that the
2 Use
refrigerator is positioned firmly and flat on the floor.
Adjustable foot
NOTE
••Position your refrigerator so that the plug is accessible.
••Keep your refrigerator out of direct sunlight.
••Do not place next to heat generating appliance.
••Do not place directly on the ground. Provide suitable stand.
••If the mains power is switched on when the door is open, the
door alarm will sound. Close the door to stop the alarm.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
right and left doors are not properly aligned, adjust
3 When
using the adjustable feet.
When the left door is
raised.
Lower the foot
at right side.
When the right door is
raised.
Lower the foot
at left side.
(Until the adjustable foot on the
other side is slightly off-ground.)
3
(B351)P2-P19_Eng.indd
3
2012/08/10
17:08:35