Download UC Voice Admin Guide

Chapter 7. Location Administration
DF bit (dfBit)
Configures the Don’t Fragment (DF) bit in the IP header to 0 or 1,
depending on what you select in the drop-down menu.
Disable Speakerphone
(disableSpeaker)
Enables/disables the speakerphone capability of the telephone.
When set to enabled, the end user can have a conversation over
the phone without taking the handset off the cradle.
Disable Speakerphone and
Headset
(disableSpeakerAndHeadset)
Enables/disables both the speakerphone and the headset
capabilities of the telephone.
Display Idle Timeout
(displayIdleTimeout)
When the display is turned on because of user activity instead of
a programmed timer, this field specifies how long the display will
remain lit. The format is in hours and minutes, where 1:15
indicates one hour and 15 minutes. If this field is left blank, the
display will turn off in one hour.
Display On Duration
(displayOnDuration)
Specifies the amount of time the display will remain lit. The
format is in hours and minutes, where 9:30 would be nine hours
and 30 minutes. If this field is left blank, then the display will
remain lit for eight hours.
Display On Time (displayOnTime)
Specifies the time of day the telephone’s display will turn on. The
time is in the 24-hour format, for example, where 13:00 is
1:00pm.
Display On When Incoming Call
(displayOnWhenIncomingCall)
Allows the phone’s display to turn on when a call is received, if
the phone’s display had turned off.
Enable Audible Alert
(enableAudibleAlert)
Causes the phone to make a warning sound ten minutes before
the phone powers off, on the days selected in the Enable Power
Save Plus field.
Enable/Disable USB Classes
(usbClasses)
Specifies which USB classes are available on the phone. The
options are:
• Mass Storage
• Human Interface Device
• Audio Class
Enable Power Save Plus
(enablePowerSavePlus)
Specifies which days the phone will be powered off according to
the times selected in the Phone Off Time and Phone On Time
fields (described below). To select more than one day, hold
down the Control key and click on each day you wish to select.
NOTE: To repower the phone after it has powered off, the user
must use a power adapter. This feature will not work on
power over the Ethernet.
Enable VXC VPN for MAC
(enableVXCVPNForMAC)
Indicates if the phone will establish a Virtualization eXperience
Client (VXC) VPN tunnel for the specified MAC address used by
the VXC device that is connected to the phone’s PC port. When
this field is:
Blank
© 2014 AT&T Intellectual Property. All rights reserved. AT&T, the Globe logo, and all other marks contained herein are trademarks or service marks
of AT&T Intellectual Property and/or AT&T affiliated companies.
152