Download Seagate ST32430N Specifications

Hard Disk Drive Tray – 525 MB Seagate Drive (ST3600N)
525 MB Seagate
drive SCSI
interface
termination
The Seagate drives have the capability to provide termination for the
SCSI interface cable. This feature is not needed for the AXM application
since a terminator is placed at the end of the SCSI cable network on the
HDDT I/O board.
The diagram illustrates the missing termination resistor modules on the
drive. Replacement drives may have these resistor modules in place.
Remove them if they are present. This applies to both possible drives in
the disk tray.
Notice that the drive is shown upside down. You cannot see the
terminator resistor module locations once the drive is installed.
No SCSI Bus
Termination
Resistor Modules
40036
12/01
Application ModuleX Service
Honeywell
69