Download Danfoss TripleLynx CN Technical data
Transcript
12. Technical Data 12.5. Auxiliary Interface Specifications Parameter Serial Communication Common cable specification RJ45 (2 pcs.) connectors Terminal block Parameter Details Cable jacket diameter (⌀) Cable type Cable Characteristic Impedance Max. cable length Wire gauge Cable shield termination Maximum wire gauge Cable shield termination Max. number of inverter nodes Galvanic interface insulation Direct contact protection Double/Reinforced insulation Short circuit protection Communication Star and daisy chain Common cable Max. cable length between inverters Specification Max. number of inverters Cable type Temperature sensor input Cable specification Cable jacket diameter (⌀) Cable type Cable shield termination Maximum wire gauge Maximum resistance per wire Maximum cable length Sensor specification Nominal resistance/temperature coefficient Measurement range Measurement accuracy Direct contact protection Double/Reinforced insulation Short circuit protection Irradiation sensor input Cable specification Cable jacket diameter (⌀) Cable type Sensor Specification Direct contact protection Short circuit protection Energy meter input Cable specification Sensor Input Specification Direct contact protection Short circuit protection Specification RS485 2 x 5-7 mm Shielded Twisted Pair (STP) (Cat 5e)2) 100 Ω – 120 Ω 1000 m 24-26 AWG (depending on mating metallic RJ45 plug) Via metallic RJ45 plug 2.5 mm2 Via EMC cable clamp 634) Yes, 500 Vrms Yes Yes Ethernet 100 m (total network length: unlimited) 1001) Shielded Twisted Pair (STP) (Cat 5e)2) 3 x PT1000 3) 4-8 mm Shielded Single Pair - 2-wire Via EMC cable clamp 2.5 mm2 10 Ω 30 m 3.85 Ω/oC -20 oC - +100 oC ±3 % Yes Yes x1 4-8 mm Shielded Single Pair - Number of wires depend on the sensor type used Cable shield termination Via EMC cable clamp Maximum wire gauge 2.5 mm2 Maximum resistance per wire 10 Ω Maximum cable length 30 m Sensor type Passive Measurement accuracy ±5 % (150 mV sensor output voltage) Output voltage of sensor 0-150 mV Max. output impedance (sensor) 500 Ω Input impedance (electronics) 22 kΩ Double/Reinforced insulation Yes Yes S0 input x1 4-8 mm Cable jacket diameter (⌀) Cable type Shielded Single Pair - 2-wire Cable shield termination Via EMC cable clamp Maximum wire gauge 2.5 mm2 Maximum cable length 30 m Sensor input class Class A Nominal output current 12 mA for an 800 Ω load Maximum short circuit output cur- 24.5 mA rent Open circuit output voltage +12 VDC Maximum pulse frequency 16.7 Hz Double/Reinforced insulation Yes Yes 12 Table 12.5: Auxiliary Interface Specifications L00410582-01_02 101