Download Delta 36-960 Instruction manual

H
G
J
Fig. 17
Fig. 16
6. Insert threaded end of support rod (G) Fig. 16,
through slot in back of saw and through hole (H) Fig. 16,
in rear trunnion. Fasten support rod (G) Fig. 16, to
trunnion using star washer and nut (J) Fig. 17. NOTE:
Thread nut (J) onto threaded end of support rod as far as
possible by hand. Using a wrench to hold nut (J) Fig. 17,
tighten rod (G) Fig. 18, using a small screwdriver (K) or
similar device through hole in end of rod (G) as shown.
G
K
7. Assemble lower bracket (L) Fig. 19, to rod (G) and
snug up with 2 one inch-long hex head screws (S) and
lockwashers, from underneath bracket (L).
Fig. 18
8. Assemble splitter bracket (M) Fig. 20, to lower bracket
(L), using one inch-long hex head screw (N), lockwasher
and flat washer. Do not fully tighten screw (N) at this time.
L
9. Fasten splitter and guard assembly (P) Fig. 21, to
bracket (M) using one inch-long hex head screw (V) and
flat washer.
S
G
Fig. 19
P
N
M
M
L
V
Fig. 20
Fig. 21
8