Download Worth Data LZ404-RF Setup guide

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
The following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec Industrie Canada RSS standard exempts de licence (s). Son
utilisation est soumise à Les deux conditions suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter Toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement du dispositif.
This device complies with Health Canada’s Safety Code 6 / IC RSS-210. The installer of this device
should ensure that RF radiation is not emitted in excess of the Health Canada’s requirement.
Information can be obtained at: http://www.hc-sc.gc.ca/ewh-semt/pubs/radiation/radio_guidelignes_
direct-eng.php
Cet appareil est conforme avec Santé Canada Code de sécurité 6 / IC RSS-210. Le programme
d'installation de cet appareil doit s'assurer que les rayonnements RF n'est pas émis au-delà de
l'exigence de Santé Canada. Les informations peuvent être obtenues: http://www.hc-sc.gc.ca/ewhsemt/
pubs/radiation/radio_guide-lignes_direct-eng.php
This device has been tested to comply with the requirements set out in the Council Directive on the
approximation of the laws of the Member States relating to Electromagnetic Compatibility Directive
(2004/108/EC) with applicable standards listed below:
EN 55022:2006+A1:2007, Class A
EN 55024:1998+A1:2001+A2:2003
EN 61000-3-2:2006+A2:2009
EN 61000-3-3:2008
The LZ360RF, LZ404RF and 520-RF models of this product have a laser scanner integrated with the scanner as
single unit. The laser used is a Class II Laser Product and has a 1.2 Milliwatt Output. To operate the laser
scanner, aim the top of the case at a bar code, and press the trigger on the scanner. The light source will turn off,
once a successful scan has occurred or 2.5 seconds has elapsed, whichever is first. Do not look directly into the
laser light source with the trigger depressed; avoid direct eye contact with the laser light source.
PROPOSITION 65 WARNING: This product, its packaging, and/or components may contain chemicals
known to the state of California to cause cancer or birth defects or other reproductive harm
Worth Data, Inc.
623 Swift Street
Santa Cruz, CA 95060
Toll free USA & Canada: 1-800-345-4220 M-F 6:30am – 4:00pm Pacific Time
Outside USA: 831-458-9938
Fax: 831-458-9964
Email: [email protected]
Website: www.barcodehq.com
2