Download Automatic Technology GDO-9V1 SecuraLift Installation manual

PARAMETERS
DOOR STATUS INDICATORS
OPEN LED
GREEN
DOOR OPENER STATE
OPEN
CLOSE LED
RED
DOOR STATUS
LED YELLOW
BEEPER
ON
ON
CLOSE
FLASHING
OPENING
FLASHING
CLOSING
DOOR TRAVEL STOPPED
FLASHING
DOOR OBSTRUCTED WHEN OPENING
FLASHING
FLASHING
DOOR OBSTRUCTED WHEN CLOSING
FLASHING
OPENER OVERLOADED
ALTERNATING
FLASHES
DOOR IN OPEN POSITION WITH
AUTO CLOSE MODE SELECTED
ONE SECOND
FLASHES
BEEPS WHILE
DOOR IS MOVING
ALTERNATING
FLASHES
RAPID
FLASHES
MAINS POWER INTERRUPTED
DOOR STATUS INDICATORS
BUTTON
FUNCTION
Operate
Opens/Stops/Closes the door
Door Code
Codes a transmitter button for Operate function
Light Code
Codes a transmitter button for light function
Door Code & Minus (-)
Codes a transmitter button for pet (pedestrian) function
Light Code & Minus (-)
Codes a transmitter button for vacation function
Force Margin Set & Pus (+)
Increases the obstruction force margin setting
Force Margin Set & Minus (-)
Decreases the obstruction force margin setting
Force Margin Set (then) Set
Reloads the factory set default obstruction force margin setting
Auto Close Time (then) Plus (+)
Increases the auto close delay time
Auto Close Time (then) Minus (-)
Decreases the auto close delay time
Auto Close Time (then) Set
Reloads the factory set default auto close delay time
Force Margin Set & Auto Close Time (then) Plus (+)
Each press of the open button increases the light time by 10 secs.
Force Margin Set & Auto Close Time (then) Minus (-)
Each press of the open button decreases the light time by 10 secs.
Force Margin Set & Auto Close Time (then) Set
Reloads the factory set default light time
Minus (-) (for 6 secs.)
Clears the door limits set positions. Limits then need to be reset.
Set & Close (for 2 secs.)
Enters pet (pedestrian) position mode.
Set (the power on) and hold until all LEDs are off
Deletes control parameters excluding transmitter storage memory.
Door Code (the power on) and hold until all LEDs are off
Deletes all transmitter storage memory.
Set & Door Code (the power on) and hold until all LEDs are off
Deletes all control parameters and transmitter storage memory.
Set
Re initialises opener obstruction force margin.
©Copyright 2006 Automatic Technology
- 21 -