Download ATON Source Input Wall PlateWallplate DHSIP Installation manual

DHTP1 Amplified Touch Pad Controller
2. Wiring/Installation
Wiring for the DHTP1 consists of a single run of
Cat-5 wire between the DH44 Digital Audio Router
or DH46X Digital Audio Expansion Router and the
mounting location for the DHTP1. If the length of the
wire run is greater than 150', it is recommended to
run an additional 16 gauge (AWG) 2-conductor wire
as well. In zones that utilize a DHSIP Source Input
Wall Plate, a single run of Cat-5 wire should also be
run from the DHSIP location to the DHTP1 location.
If an external IR Receiver such as ATON’s AIR5 IR Receiver is to be used, run Cat-5 wire from the mounting location of the IR Receiver to the DHTP1 location.
Note: Do not run Cat-5 wires closer than 12"
from high voltage wires.
Note: Using only Cat-5 wiring, the maximum wire
run between the DHTP1 and DH44/DH46X is
300'. Runs over 300' require a separate 16AWG
2-conductor wire in addition to Cat-5. The
maximum wire run using Cat-5 and 16 AWG, 2
conductor wire is 600’.
6
©2007 • All rights reserved.