Download Boost Force Instruction manual

Transcript
solenoid valve installation
Mount the solenoid valve in a position away from significant heat sources (such as the exhaust manifold and
turbine), and where it is protected from rain or splashed water. The unused outlet of the solenoid valve should be
positioned facing downwards to avoid ingress of dust, dirt and water.
DO NOT plug the un-used solenoid port, as this will prevent the controller from being able to adjust boost pressure.
Internal Wastegate
Screw the two supplied hose
tails into ports 2 and 3 of the
solenoid valve, and connect
the ports to the correct
locations as shown using the
supplied 3/16” hose.
Port 2
Port 3
Boost pressure
source
Wastegate
actuator
Turbo
External Wastegate
Screw the two supplied hose
tails into ports 1 and 2 of the
solenoid valve, and connect
the ports to the correct
locations as shown using the
supplied 3/16” hose.
Wastegate
Boost pressure
source
Large Tee
Port 1
Port 2
Turbo
Top port
Bottom port
4 - installation