Download Edge10 C171 Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
DGS-3450:4#show config current_config
Command: show config current_config
#------------------------------------------------------------------------------#
DGS-3450 Gigabit Ethernet Switch
#
Configuration
#
#
Firmware: Build 2.00-B48
#
Copyright(C) 2004-2007 D-Link Corporation. All rights reserved.
#------------------------------------------------------------------------------# STACK
##Box
##ID
##-----# 1
# 2
# 3
# 4
# 5
# 6
Type
------DGS-3426P
DGS-3426
DGS-3450
Not_Exist
Not_Exist
Not_Exist
Exist
--------exist
exist
exist
no
no
no
Prio
rity
------16
32
32
upload
Purpose
Used to upload switch settings or the switch history log to a TFTP.
Syntax
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
{<config_id 1-2>} | log_toTFTP [<ipaddr> | <ipv6addr>] <path_filename
64>] | attack_log_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>]
{unit <unit_id 1-12>}]
Description
This command is used to upload either the Switch’s current settings or the
Switch’s history log to a TFTP server.
Parameters
cfg_toTFTP − Specifies that the Switch’s current settings will be uploaded
to the TFTP server.
• <ipaddr> − The IPv4 address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
• <ipv6addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
• <path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
• <config_id 1-2> - Entering this parameter will upload configurations
to be specified, which were saved in NV-RAM to TFTP server.
log_toTFTP − Specifies that the switch history log will be uploaded to the
TFTP server.
• <ipaddr> − The IP address of the TFTP server. The TFTP server
must be on the same IP subnet as the Switch.
• <ipv6addr> − The IPv6 address of the TFTP server. The TFTP
server must be on the same IP subnet as the Switch.
• <path_filename 64> − Specifies the location of the Switch
configuration file on the TFTP server. This file will be replaced by
the uploaded file from the Switch.
attack_log_toTFTP - This command is used to upload a switch attack log to
a TFTP server, such as a spoofing attack.
• <ipaddr> - Enter the IPv4 address of the TFTP server to which to
upload the attack log.
• <ipv6addr> - Enter the IPv6 address of the TFTP server to which to
54