Download Edge10 C171 Specifications

xStack DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
show config
Purpose
Used to display the current or saved version of the configuration settings of
the switch.
Syntax
show config [current_config | config_in_nvram <config_id 1-2> |
information]
Description
Use this command to display all the configuration settings that are saved to
NV RAM or display the configuration settings as they are currently
configured. Use the keyboard to list settings one line at a time (Enter), one
page at a time (Space) or view all (a).
The configuration settings are listed by category in the following order:
1. Stack
2. Double VLAN
3. Basic (serial port, Telnet
and web management
status)
4. Account List
5. storm control
6. IP group management
7. syslog
8. QoS
9. port mirroring
10. traffic segmentation
11. SSL
12. port
13. PoE
14. Port lock
15. SNMPv3
16. MANAGEMENT
17. VLAN
18. 802.1X
19. Guest VLAN
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
35.
36.
37.
38.
TR
ACL
FDB (forwarding data base)
Address Binding
MAC Address Table
Notification
STP
SAFEGUARD ENGINE
BANNER PROMPT
SSH
SNTP
LACP
IP and auto config
IGMP Snooping
MLD Snooping
ACCESS
AUTHENTICATION
CONTROL
DHCP Relay
IPv6 Neighbor Detection
ARP
Route
Parameters
current_config – Entering this parameter will display configurations entered
without being saved to NVRAM.
config_in_nvram <config_id 1-2> - Entering this parameter will display
configurations to be specified <config_id 1-2> which were saved in NVRAM.
Restrictions
None.
Example usage:
To view the current configuration settings:
53