1
Download MATLAB XPC TARGET 4 - DEVICE DRIVERS Specifications
Transcript
11 Gespac GESPIA-2A Digital Output Use a separate diver block for each port. By selecting the digital output driver block, the port is configured as output. Scaling Input to Output Hardware Output Block Input Data Type Scaling TTL double < 0.5 = TTL low > 0.5 = TTL high Driver Block Parameters Number of Channels - Enter a number between 1 and 8 to select the number of digital output lines used with this port. Port Name. From the list, choose either PIA0A, PIA0B, PIA1A or PIA1B to identify the port used with this block of I/O lines. Sample Time - Enter a base sample time or a multiple of the base sample time. BaseAddress - Enter the base address of the board. This entry must corresponds to the DIP-switch settings on the board. For example, if the base address is 300 (hexadecimal), enter 0x300 11-8
