Download protech PROX-1750 Technical data

Make sure the ground is level
and firm and park the motorcycle.
Switch off the ignition.
To ensure a secure position,
install lever 4 on the short side
of the stand.
Remove the covers 1 on the
high-beam bulbs and/or the
cover 2 on the low-beam bulbs
by turning counterclockwise.
Push rear wheel stand from left
into rear axle.
Mount lock washer 2 from right
by pressing release button.
105
z
Lamps
Replacing low-beam and
high-beam bulbs
Position motorcycle upright
while simultaneously pressing
8
Maintenance
grip of stand back so that both
stand rollers rest on ground.
Then press the grip down to
the ground.
The alignment of the connector may differ from the
illustration depending on the bulb
to be replaced.