Download Rojone EziTrak Micro ETM01 User manual

®
EziTRAK A-300ET User Manual
6 PARAMETER LIST
6.1 Parameters value types
•
•
•
•
•
•
•
S8
S8[n]
U8
U16
S32
U32
U64
– Signed Char
– String of n Char
– Unsigned Char
– Unsigned Short
– Signed Integer
– Unsigned Integer
– Unsigned Long Long Integer
6.2 System parameters
6.2.1
Deep Sleep Mode (ID=1000)
Device can operate in three modes: active, GPS Sleep or deep sleep. In active mode (value 0)
module is able to operate all tasks, while in GPS Sleep mode (value 1) only the GPS is turned off to
conserve power but the phone module is still active, while in deep sleep mode (value 2) the GPS and
phone module are turned off reducing the level of power usage.
Minimum
value
Maximum
value
Recommended
value
0
2
-
6.2.2
Goes with (depends on)
parameters
Value type
U8
Analog Input value range (ID=1001)
Analog input measuring resolution and range can be defined as 0…10V (value 0) or 1…30V (value 1).
Minimum
value
Maximum
value
Recommended
value
0
1
-
6.2.3
Goes with (depends on)
parameters
Value type
U8
Stop Detection Source (ID=1002)
Device can operate and change its working mode according to motion detection source: ignition
(value 0), movement sensor (value 1), GPS (value 2).
Minimum
value
Maximum
value
0
2
6.2.4
Recommended
value
Goes with (depends on)
parameters
Value type
8.5 Data Acquisition Modes
parameters
U8
Static Navigation (ID=1003)
When static navigation is enabled, 300ET filters out GPS jumps, when it is not moving. When it is
disabled, it does not make any changes to collected GPS data.
Minimum
value
Maximum
value
Recommended
value
0
1
1
version 1
Goes with (depends on)
parameters
Value type
U8
Page 32