Download Alesis 2 Specifications
Transcript
8.1 APPENDIX 2: INTERFACE INFORMATION 8.1A Sony Editor Constants If your editor does not recognize the SONY PCM-7030 machine ID, the editor machine constants should be set as follows: Constant Values (in hexadecimal) VTR Item number PCM-7030 (30 Fr) 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 70 00 00 96 05 05 03 80 0A 07 FF 00 00 5C FF Description of VTR Constant settings Item Number Setting Details of Setting 1 DEVICE TYPE (most significant byte) Specifies the VTR device type. Normally it is not necessary to change this from hexadecimal FFFF. 2 DEVICE TYPE (least significant byte) Factory default: FFFF (hexadecimal) 3 PREROLL TIME (minimum preroll time, most significant byte) Specifies the minimum preroll time required by the VTR. 4 PREROLL TIME (minimum preroll time, least significant byte) 5 EDIT DELAY Corrects for the delay (in frames) from a VTR receiving a Record command until it actually starts recording. 6 EE DELAY Corrects for the delay (in frames) from a VTR receiving a PB/EE command, until it actually enters the preview mode. 7 OVER RUN (overrun time) Corrects for the time (in frames) for which the tape overruns the specified preroll point in a preroll stop. 8 TRAJECTORY Specifies the optimum speed curve for preroll. 9 TC READ DELAY (time code read delay) Corrects for the delay (in frames) from tape movement starting until the VTR is able to read the time code. 10 START DELAY Corrects for the delay in frames from a VTR receiving a tape transport command until it actually starts moving the tape. 71