Download Directed Electronics RSIII Installation guide

GREEN (-) Multiplex Input
If installing an optional Directed dual-stage sensor, connect to the GREEN wire off the shock
sensor harness.
RED and BLACK: RED is (+)12V Constant, BLACK is (-) Ground
Do not use these for anything besides the plug-in shock sensor.
Mounting the Transceiver
Two-way in-vehicle transceiver position should be discussed with the vehicle owner prior to installation, since the antenna may be visible to the vehicle’s operator.
The best location for the two-way in-vehicle transceiver is centered high on either the front or rear
windshield. For optimal range, the antenna should be mounted horizontally. Metallic window tint
can also affect range, so this should be a consideration when determining the mounting location.
After determining the best mounting location, follow these steps:
1.
2.
3.
4.
Clean the mounting area with a quality glass cleaner or alcohol to remove any dirt or residue.
Plug the two-way in-vehicle transceiver cable into the two-way in-vehicle transceiver.
Mount the two-way in-vehicle transceiver using the supplied double-sided tape.
Route the two-way in-vehicle transceiver cable to the control module and plug it into the fourpin antenna connector.
IMPORTANT! To achieve the best possible range, DO NOT leave the antenna cable
bundled under the dash. Always extend the cable full length during installation,
regardless of the antenna mounting location.
TWO-WAY IN-VEHICLE
TRANSCEIVER CABLE
TWO-WAY IN-VEHICLE
TRANSCEIVER
DRW-365
CONTROL
MODULE
©
2003 Directed Electronics, Inc.
21