Download Siemens SINUMERIK 802D sl Specifications

Overview of alarms
06/2007
NCK alarms/ISO alarms
Remedy:
Change part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
14088
Channel %1 block %2 axis %3 doubtful position
Parameters:
%1 = Channel number.
%2 = Block number, label.
%3 = Axis name, spindle number.
Definitions:
An axis position larger than 3.40e+38 increments has been programmed.
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Change part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
14090
Channel %1 block %2 invalid D number
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
A value less than zero has been programmed under address D.
A set of parameters with 25 correction values has been automatically assigned to each active tool.
Each tool can have 9 sets of parameters (D1 - D9, initial setting is D1). When the D number changes,
the new parameter set is active (D0 is used for deselecting the correction values).
N10 G.. X... Y... T15 ; Parameter set D1 of T15 active
N50 G.. X... D3 M.. ; Parameter set D3 of T15 active
N60 G.. X.. T20
; Parameter set D1 of T20 active
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Program D numbers in the permissible value range (D0, D1 to D9).
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
14091
Channel %1 block %2 illegal function, index %3
Parameters:
%1 = Channel number
%2 = Block number, label
%3 = Index
Definitions:
A function was programmed which is not allowed in the current program context. The code of the function in question is entered in "index":
Index = 1: "RET" command was programmed in the main program level
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Index = 1: Substitute "RET" command with M17/M30.
Program Continuation:
Clear alarm with the RESET key. Restart part program
14092
Parameters:
Channel %1 block %2 axis %3 is wrong axis type
%1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions:
Reaction:
Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy:
Modify part program.
Program Continuation:
Clear alarm with NC START or RESET key and continue the program.
2-124
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition