Download Siemens SINUMERIK 802D sl Specifications

Overview of alarms
06/2007
NCK alarms/ISO alarms
10930
Channel %1 block %2 interpolation type not allowed in stock removal
contour
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The contour of the stock removal cycle (CYCLE 95) contains different path commands than: G00,
G01, G02, G03, CIP or CT. The contour program may only contain contour elements that derive from
these path conditions (i.e. no thread blocks, no spline blocks, etc.).
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Only program path elements that consist of straight lines or circles as a stock removal contour.
Program Continuation:
Clear alarm with the RESET key. Restart part program
10931
Channel %1 block %2 incorrect stock removal contour
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The contour of the stock removal cycle (CYCLE 95) contains different path commands than:
Full circle
Overlapping contour elements
Wrong start position
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
The above errors must be corrected in the program for the stock removal contour.
Program Continuation:
Clear alarm with the RESET key. Restart part program
10932
Channel %1 block %2 preparation of contour has been restarted
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The stock removal cycle CYCLE 95 was interrupted during a preparatory phase of the stock removal
contour.
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
No interruptions are permitted during contour preparation in the stock removal cycle CYCLE 95.
Program Continuation:
Clear alarm with the RESET key. Restart part program
10933
Channel %1 block %2 contour programm does not contain enough
contour blocks
Parameters:
%1 = channel number
%2 = block number, label
Definitions:
The program in which the stock removal contour is programmed contains fewer than 3 blocks with
motions in both axes in the machining plane. The cutting cycle (CYCLE 95) has been aborted.
Reaction:
Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
Increase the size of the program with the stock removal contour to include at least 3 NC blocks with
movements in both axes of the current machining plane.
Program Continuation:
Clear alarm with the RESET key. Restart part program
2-84
" Siemens AG 2007 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition