Download PRG Series 400 User manual

Breakout Box Mounting Options
Breakout Boxes can be hung horizontally or vertically from any appropriate truss or structure. The Breakout Box
provides threaded holes for mounting by wingbolts, along with two additional holes for attaching a clamp bracket or a
variety of other hooks. The Mega-Claw truss hook is shown in these examples, however, other compatible truss
hooks are available from different manufacturers.
CAUTION: A safety cable should be used in all mounting configurations. Attach as shown.
Wingbolt
Wingbolts are provided for mounting on standard 2-inch round truss pipe.
Wingbolts
Safety Cable
Attach safety cable
at two hole locations
Breakout Box
Truss Pipe
15A 208V MODEL SHOWN
Rack Components May Vary
SIDE VIEW
Figure 2-13: Wingbolt Mounting Method
Clamp Bracket Rail
In order to accommodate other mounting hooks, a clamp bracket rail (also used with VARI❋LITE® Series 1000™,
2000™ and 3000™ luminaires) can be attached. The bracket requires two bushings, screws, nuts and the bracket
itself (refer to "Accessories" on page 12 for part numbers).
Screw
Bracket
Procedure:
1. Install bushings.
2. Install bracket, locking into place.
3. Install truss hook.
Bushing
Locking Mechanism
Truss Hook
(not included)
Bracket
Press up when
installing or releasing
Nut
Truss Hook Hardware
(not provided)
Figure 2-14: Installing Clamp Bracket
PRG SERIES 400® POWER AND DATA DISTRIBUTION SYSTEM USER MANUAL
33