Download Wavecom GS64 Specifications
Transcript
Product Technical Specification & Customer Design Guidelines Interfaces 3.12.3 Application The maximum peak current is 100 mA and the maximum average current is 40 mA. A diode against transient peak voltage must be added as described below. VCC R1 D1 Q64 C1 BUZZER Figure 24: Example of buzzer implementation Where: R1 must be chosen in order to limit the current at IPEAK max and must be adjusted in function of the frequency and the duty cycle used. C1 = 0 to 100 nF (depending on the buzzer type) D1 = BAS16 (for example) A low filter is recommended at low frequencies. Calculation of the Low Filter: Req is the total resistor in line. C is the capacitive charge on BUZZER signal and the ground The cut-off frequency (Fc) must be higher than FBUZZER Due to the conception of the signal, the frequency modulation of the BUZZER signal is 64 * FBUZZER FC must be at least 64 * FBUZZER. FC = 1 / (2.π.Req.C) © Confidential Page: 68 / 116 This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without prior written agreement. WA_DEV_Q64_PTS_001-003 January 9, 2009