1
Download Akai MPC Operator`s manual
Transcript
28 Chapter 4: Editing sequences Changing the timing of an event (SHIFT TIMING) You can shift the timing of the note event. 01. Select the Edit field in the EVENT page of the SEQ EDIT mode, and select SHIFT TIMING. The various fields necessary for the Shit Timing will be displayed. 04. In the MODE field, choose the method of velocity change. ADD VALUE: Adds the value selected in the Value: field to the note. SUB VALUE: Subtracts the value selected in the Value: field from the note. MULTI VAL%: Multiplies the Velocity (percent) by the value selected in the Value: field. SET TO VALUE: Sets the note to the Velocity selected in the Value: field.. 05.In the Value field, set the value to be adjusted. 02. In the time field and the Notes field, select the region that you wish to edit. 03. In the Edit sq field and the Tr field on right, select the sequence and track that you wish to edit. In the Edit sq field and the Tr field, you can select ALL by turning the DATA wheel. When you select ALL, the MPC2500 will shift the timing of all the sequence and tracks. . 04. In the Amount field, set the amount of Shift timing. You can set by tick. 05. Select the direction of Shift Timing. EARIER: LATAR: Shits forwards Shifts back You can set the Value between 0 and 127. When you select “MULTI VAL%” in the Mode field, you can set the Value between 0 and 200. 06. Press the F6 (DO IT) key The MPC2500 will start processing your changes. Changing the duration of an event (DURATION) You can change the Duration of any note event. 01. Select the Edit field in the EVENT page of the SEQ EDIT mode, and select DURATION. The various fields necessary for changing the duration will be displayed. 06. Press the F6 (DO IT) key The MPC2500 will start processing your changes. Changing the Velocity of an event (Velocity) 02. In the time field and the Notes field, select the region that you wish to edit. You can change the velocity of any note event. 01. Select the Edit field in the EVENT page of the SEQ EDIT mode, and select Velocity. The various fields necessary for changing the velocity will be displayed. 03. In the Edit sq field and the Tr field on right, select the sequence and track that you wish to edit. In the Edit sq field and the Tr field, you can select ALL by turning the DATA wheel. When you select ALL, the MPC2500 will change the Duration of the sequence and all its track. 04. In the MODE field, select how you want to change the Duration. 02. In the time field and the Notes field, select the region that you wish to edit. 03. In the Edit sq field and the Tr field on right, select the sequence and track that you wish to edit. In the Edit sq field and the Tr field, you can select ALL by turning the DATA wheel. When you select ALL, the MPC2500 will change the velocity of the sequence and all its tracks. MPC2500 Operator’s Manual rev 1.0 ADD VALUE : Adds the value selected in the Value: field to the note. SUB VALUE : Subtracts the value selected in the Value: field from the note. MULTI VAL% : Multiplies the Velocity (percent) by the value selected in the Value: field. SET TO VALUE : Sets the note to the Velocity selected in the Value: field..
